Microstrip RF Antenna / Coupler

Project overview

Printed RF structure demonstrating controlled-impedance transmission and radiating/coupling behavior.

Engineering approach

RF and microwave PCB work depends on controlled impedance and careful trace geometry, since even small layout mistakes at these frequencies show up directly as signal loss. On this board, that translates into a component set built around 2L and Microstrip/printed antenna structure, with layout and stack-up decisions driven by impedance-controlled routing, trace geometry, and minimizing insertion loss across the target frequency range.

Technical specification

Engineering focus

This portfolio project demonstrates CircuitNexa's electronics engineering and PCB design work in the rf pcbs space. The design shown here is part of a broader portfolio spanning schematic capture, PCB layout, embedded firmware, prototyping, and support through to manufacturing.